Chamfer inside and out, lube and run through the resizing die. I place an empty 223 case and cut to 24.74 mm. I cut a grove in a piece of wood and after cutting a slot with the cutoff saw, pressed a thin washer as a stop. Harbor Freight sells a 2" cut off saw that cuts cases just fine. I cut 223 brass down and reform with the Lee Sizer/Decapper die. Powder type Filling/Loading Ratio Charge Charge Vel. Actual load order can vary, depending upon lot-to-lot powder and component variations. That all of the listed powders can be unsuitable for the given combination of cartridge, bulletĪnd gun. Loads or exceeds maximum suggested loads as presented in current handloading manuals. These calculations refer to your specified settings in QuickLOAD 'Cartridge Dimensions' window.Ĭ A U T I O N : any load listed can result in a powder charge that falls below minimum suggested Or a maximum loading ratio or filling of 105 % Matching Maximum Pressure: 35000 psi, or 241 MPa
Predicted Data for Indicated Charges of the Following Powders.
0 kommentar(er)
